Using flue gas desulfurization gypsum to remove dissolved phosphorus from agricultural drainage waters

High levels of accumulated phosphorus (P) in soils of the Delmarva Peninsula are a major source of dissolved P entering drainage ditches that empty into the Chesapeake Bay. The objective of this study was to design, construct, and monitor a within-ditch filter to remove dissolved P, thereby protecting receiving waters against P losses from upstream areas. In April 2007, 110 Mg of flue gas desulfurization (FGD) gypsum, a low-cost coal combustion product, was used as the reactive ingredient in a ditch filter. The ditch filter was monitored from 2007 to 2010, during which time 29 storm-induced flow events were characterized. For storm-induced flow, the event mean concentration efficiency for total dissolved P (TDP) removal for water passing through the gypsum bed was 73 ± 27% confidence interval (α = 0.05). The removal efficiency for storm-induced flow by the summation of load method was 65 ± 27% confidence interval (α = 0.05). Although chemically effective, the maximum observed hydraulic conductivity of FGD gypsum was 4 L s(-1), but it decreased over time to <1 L s(-1). When bypass flow and base flow were taken into consideration, the ditch filter removed approximately 22% of the TDP load over the 3.6-yr monitoring period. Due to maintenance and clean-out requirements, we conclude that ditch filtration using FGD gypsum is not practical at a farm scale. However, we propose an alternate design consisting of FGD gypsum-filled trenches parallel to the ditch to intercept and treat groundwater before it enters the ditch.     

Repellent scent-marking of flowers by a guild of foraging bumblebees (Bombus spp.)

We have found that foraging bumblebees (Bombus hortorum, B. pascuorum, B. pratorum and B.␣terrestris) not only avoid flowers of Symphytum officinale that have recently been visited by conspecifics but also those that have been recently visited by heterospecifics. We propose that the decision whether to reject or accept a flower is influenced by a chemical odour that is left on the corolla by a forager, which temporarily repels subsequent foragers. Honeybees and carpenter bees have previously been shown to use similar repellent forage-marking scents. We found that flowers were repellent to other bumblebee foragers for approximately 20 min and also that after this time nectar levels in S. officinale flowers had largely replenished. Thus bumblebees could forage more efficiently by avoiding flowers with low rewards. Flowers to which extracts of tarsal components were applied were more often rejected by wild B. terrestris workers than flowers that had head extracts applied, which in turn were more often rejected than flowers that had body extracts applied. Extracts from four Bombus species were equally repellent to foragers. The sites of production of the repellent scent and its evolutionary origins are discussed. Received: 24 November 1997 / Accepted after revision: 8 March 1998     

Transport of atmospheric fine particulate matter: part 2--findings from recent field programs on the intraurban variability in fine particulate matter

Air quality field data, collected as part of the fine particulate matter Supersites Program and other field measurements programs, have been used to assess the degree of intraurban variability for various physical and chemical properties of ambient fine particulate matter. Spatial patterns vary from nearly homogeneous to quite heterogeneous, depending on the city, parameter of interest, and the approach or method used to define spatial variability. Secondary formation, which is often regional in nature, drives fine particulate matter mass and the relevant chemical components toward high intraurban spatial homogeneity. Those particulate matter components that are dominated by primary emissions within the urban area, such as black carbon and several trace elements, tend to exhibit greater spatial heterogeneity. A variety of study designs and data analysis approaches have been used to characterize intraurban variability. High temporal correlation does not imply spatial homogeneity. For example, there can be high temporal correlation but with spatial heterogeneity manifested as smooth spatial gradients, often emanating from areas of high emissions such as the urban core or industrial zones.     

The potential of algae blooms to produce renewable gaseous fuel

Ulva lactuca (commonly known as sea letuce) is a green sea weed which dominates Green Tides or algae blooms. Green Tides are caused by excess nitrogen from agriculture and sewage outfalls resulting in eutrophication in shallow estuaries. Samples of U. lactuca were taken from the Argideen estuary in West Cork on two consecutive years. In year 1 a combination of three different processes/pretreatments were carried out on the Ulva. These include washing, wilting and drying. Biomethane potential (BMP) assays were carried out on the samples. Fresh Ulva has a biomethane yield of 183 L CH₄/kg VS. For dried, washed and macerated Ulva a BMP of 250 L CH₄/kg VS was achieved. The resource from the estuary in West Cork was shown to be sufficient to provide fuel to 264 cars on a year round basis. Mono-digestion of Ulva may be problematic; the C:N ratio is low and the sulphur content is high. In year 2 co-digestion trials with dairy slurry were carried out. These indicate a potential increase in biomethane output by 17% as compared to mono-digestion of Ulva and slurry.     

A new condensed toluene mechanism for Carbon Bond: CB05-TU

Toluene is ubiquitous in urban atmospheres and is a precursor to tropospheric ozone and aerosol (smog). An important characteristic of toluene chemistry is the tendency of some degradation products (e.g., cresols and methyl-catechols) to form organic nitro and nitrate compounds that sequester NOx (NO and NO₂) from active participation in smog formation. Explaining the NOx sinks in toluene degradation has made mechanism development more difficult for toluene than for many other organic compounds. Another challenge for toluene is explaining sources of radicals early in the degradation process. This paper describes the development of a new condensed toluene mechanism consisting of 26 reactions, and evaluates the performance of CB05 with this new toluene scheme (Toluene Update, TU) against 38 chamber experiments at 7 different environmental chambers, and provides recommendations for future developments. CB05 with the current toluene mechanism (CB05-Base) under-predicted the maximum O₃ and O₃ production rate for many of these toluene–NOx chamber experiments, especially under low-NOx conditions ([NOx]_t=0 < 100 ppb). CB05 with the new toluene mechanism (CB05-TU) includes changes to the yields and reactions of cresols and ring-opening products, and showed better performance than CB05-Base in predicting the maximum O₃, O₃ formation rate, NOx removal rate and cresol concentration. Additional environmental chamber simulations with xylene–NOx experiments showed that the TU mechanism updates tended to improve mechanism performance for xylene.     

Comparison of surface emissions and subsurface distribution of cis- and trans-1,3-dichloropropene and chloropicrin in sandy field beds covered with four different plastic films

The purpose of this study was to conduct a field study at a Florida field site on surface emissions and subsurface distribution of cis-and trans-1,3-dichloropropene (1,3-D) and chloropicrin (CP) in raised beds injected with Telone C35 with four replications. A total of 16 beds were applied with Telone C35 by chisel injection and covered with four different plastic films, 4 beds for each film. Each bed was installed with five 20-cm long soil pore air probes and a surface air collection pan at arbitrarily locations along the length of each bed for sampling soil pore air and surface air, respectively, for analysis of the three biologically active compounds, cis- and trans-1,3-D and CP. We found that average concentrations of the three compounds at 20-cm depth among the beds covered with four different plastic films generally were not statistically different. Among the four beds covered with the same plastic film, average concentrations of the three compounds were statistically different only in the four metallic PE covered beds at 5 and 24 hours after injection. Volatilization rates of the three compounds among the beds covered with four different plastic films, with the exception of CP at 48 hours after injection, were not statistically different. It appeared that initial upward diffusion and volatilization flux were influenced by solar radiation. Initial subsurface concentrations of the three compounds and volatilization flux, especially cis-1,3-D, were greater in the beds on the east side of the field than that in the beds on the west side of the field. Whether or not difference in initial subsurface concentrations of the compounds between east side beds and west side beds may influence fumigant efficacy remains to be determined.     

一种改进的多学习教与学优化算法

针对传统教与学算法在解决复杂多峰函数优化问题时,具有局部最优且搜索开发能力较差的缺点,提出了一种改进的多学习教与学优化算法,新算法为学员的每一维加入不同的教学因子,设计了基于学员均值比较的教师选择策略和向教师及学员学习的多学习策略。基于多个单峰和多峰函数的仿真结果表明,新算法跟传统的、改进的教与学算法相比,在稳定性、寻优精度和收敛速度方面更具优势。     

Effect of liquid swine manure rate, incorporation, and timing of rainfall on phosphorus loss with surface runoff

Excessive manure phosphorus (P) application increases risk of P loss from fields. This study assessed total runoff P (TPR), bioavailable P (BAP), and dissolved reactive P (DRP) concentrations and loads in surface runoff after liquid swine (Sus scrofa domesticus) manure application with or without incorporation into soil and different timing of rainfall. Four replicated manure P treatments were applied in 2002 and in 2003 to two Iowa soils testing low in P managed with corn (Zea mays L.)-soybean [Glycine max (L.) Merr.] rotations. Total P applied each time was 0 to 80 kg P ha(-1) at one site and 0 to 108 kg P ha(-1) at the other. Simulated rainfall was applied within 24 h of P application or after 10 to 16 d and 5 to 6 mo. Nonincorporated manure P increased DRP, BAP, and TPR concentrations and loads linearly or exponentially for 24-h and 10- to 16-d runoff events. On average for the 24-h events, DRP, BAP, and TPR concentrations were 5.4, 4.7, and 2.2 times higher, respectively, for nonincorporated manure than for incorporated manure; P loads were 3.8, 7.7, and 3.6 times higher; and DRP and BAP concentrations were 54% of TPR for nonincorporated manure and 22 to 25% for incorporated manure. A 10- to 16-d rainfall delay resulted in DRP, BAP, and TPR concentrations that were 3.1, 2.7, and 1.1 times lower, respectively, than for 24-h events across all nonincorporated P rates, sites, and years, whereas runoff P loads were 3.8, 3.6, and 1.6 times lower, respectively. A 5- to 6-mo simulated rainfall delay reduced runoff P to levels similar to control plots. Incorporating swine manure when the probability of immediate rainfall is high reduces the risk of P loss in surface runoff; however, this benefit sharply decreases with time.